ESP 01S DEvelopment Board


199 Inc GST

ESP 01S Development Board

 

  • To program, you have to toggle the GPIO 0 “PRGM” pin to the ground.
  • Hook it up to an FTDI  using this breakout board making sure it’s configured for 3.3V.
  • Program it through the Arduino IDE. After you click the “Program” button in Arduino.
  • 4 GPIOS available ( RX / TX / GPIO 0 / GPIO 2 )

 

SPECIFICATIONS

 

  • 8Mbit external QSPI flash memory (1MByte)
  • 32-bit Tensilica Xtensa LX106 CPU running 80MHz
  • 3.3V supply (current can spike 300mA+, depending on model)
  • PCB-trace antenna
  • 2 x 4 dual-in-line pinout
  • 2.5 cm x 1.0 cm x 1.0 cm
SKU: PRA-RC-0595 Category:

SHOPPING CART

close
Select an available coupon below
× How can I help you?